Neu-f NF.2201 Manuel d'utilisateur télécharger pdf

Reproduction in whole or in part prohibited.

DOC.NF.2201 Rev. 11.15.2013

neuf • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX

www.neu-f.com

TORQUE ARM INSERT

2012-14 Fiat 500 Abarth

PART # NF.2201

INSTALLATION INSTRUCTIONS

PART LIST: 1 – Torque Arm Insert

TOOLS REQUIRED: 1 – E18 External Torx Wrench 2 – 18mm Wrench

or 14mm Box End Wrench

1. Park car on a flat, level surface capable of

supporting the vehicle’s weight on jack and jack

stands. Using the manufacturer’s recommended

lifting point(s), raise front of vehicle and support

with jack stands. NEVER WORK ON A

VEHICLE SUPPORTED ONLY WITH A JACK!

2. Unbolt rear most torque arm bolt using E18 or

14mm wrench. To completely remove bolt pull

down on exhaust pipe.

NOTE: Some aftermarket exhaust front pipe

may need to be unbolted from catalytic

converter and dropped down to allow removal of

bolt.

3. Only loosen front torque arm bolt using 18mm

wrench on bolt head and holding 18mm wrench

on nut.

4. Swing down torque arm.

5. Install Urethane insert from passenger side of

arm.

6. Push back up into place, install bolt and then

tighten both bolts.

7. Reconnect exhaust if necessary.

Pas de commentaire

Neu-f NF.2201 Manuel d'utilisateur